wafer.space Community - Metal- and Module Selection for Run3

Is the exact metal code and module selection for run 3 documented anywhere? On the Crowd Supply page, I can only find the code 1P5M26ML, so 5 metal layers, but I can't find any reference to 26ML anywhere in the PDK. From my understanding, all of the following modules must be specified for a gf180mcu run to be fully defined:

==============================================================================
| Metal Stack | Top Metal | MIM Layer | MIM Cap   | PHRES       | nVt NMOS   |
|=============|===========|===========|===========|=============|============|
| 1P5M        | 6KA       | no MIM    | no MIM    | no PHRES    | no nVtNMOS |
|             | 9KA       | Option A  | 1.5fF/um2 | 1000 ohm/sq | nVtNMOS    |
|             | 11KA      | Option B  | 1.0fF/um2 | 2000 ohm/sq |            |
|             | 30KA      |           | 2fF/um2   | 3000 ohm/sq |            |
==============================================================================

Has anyone come across this before or has any information about it?

26ML just mean it has 26 Mask Layers.

7:14 p.m.

11KA
MiM Option B
2 fF/um^2
1000 ohm/sq

Thanks! Did you find that somewhere on the wafer.space site?

No, just from previous discussions here ...

1

Lukas

Is the exact metal code and module selection for run 3 documented anywhere? On the Crowd Supply page, I can only find the code 1P5M26ML, so 5 metal layers, but I can't find any reference to 26ML anywhere in the PDK. From my understanding, all of the following modules must be specified for a gf180mcu run to be fully defined:

==============================================================================
| Metal Stack | Top Metal | MIM Layer | MIM Cap   | PHRES       | nVt NMOS   |
|=============|===========|===========|===========|=============|============|
| 1P5M        | 6KA       | no MIM    | no MIM    | no PHRES    | no nVtNMOS |
|             | 9KA       | Option A  | 1.5fF/um2 | 1000 ohm/sq | nVtNMOS    |
|             | 11KA      | Option B  | 1.0fF/um2 | 2000 ohm/sq |            |
|             | 30KA      |           | 2fF/um2   | 3000 ohm/sq |            |
==============================================================================

Has anyone come across this before or has any information about it?

oh, nvt NMOS is allowed as well. Extraction for thin oxide ones is maybe still not available; but worse, there are no SPICE yet for thin oxide nvt NMOS.

There is no thin oxide on GF180MCU, only thick oxide and thicker oxide IIRC

well, yeah, afaik all the gf180 options never offer more than two thicknesses at once, thus if there's even a difference available, there'll be a "thin" and a "thick" with local meaning.

namibj

well, yeah, afaik all the gf180 options never offer more than two thicknesses at once, thus if there's even a difference available, there'll be a "thin" and a "thick" with local meaning.

I think you might be right there.